The Die Casting process involves forcing molten metal into a mold or die. It is strictly a non-ferrous process with aluminum and zinc being the predominant materials. It is generally considered to be the highest volume of the casting processes. Die casting is considered by many to be two processes depending upon the material being cast. There are two types of die casting equipment used depending upon the material being cast. Cold chamber die casting is used for materials with a higher melting point such as aluminum. It is referred to as cold chamber because metal is ladled into the machine one shot at a time. Hot chamber die casting is for materials with a lower melting point such as zinc. Here the metal can be pumped directly from the furnace into the machine.
Tolerance +/- .015 as a general rule of thumb. Tighter tolerance is certainly available.
Draft – One degree, two degrees on cored features. Additional draft will endear you to your die caster and could extend tool life
Finish – 32 to 60 micro inch. Finer surface finish can be achieved, but often results in more frequent tool maintenance.
Wall thickness – .050” to .500. One should always strive to keep wall thicknesses as close as possible. Sharp corners should always be avoided.
Cavitation – Multiple cavity tooling results in a lower cost per part, yet a higher tooling cost. Volume and the expected life of the part are the prime considerations here.
Features -Part features to be formed by slides can save a secondary operation but increase the cost of the tool. Such features also increase the complexity of the die and naturally can affect its reliability.
Tool life – Aluminum tooling is usually good for 50,000-100,000 cycles (shots) before wear will start to become evident. Wear normally begins to show up in corners and fine detail in the part such as raised letters. Assume twice the tool life for hot chamber tooling. Less heat, less pressure, longer life.
Ownership – Die cast tooling is generally the property of the customer. Be aware if buying insert type tooling which fits into standard sized die sets. Not every die caster will have the die set that will enable your tooling to work. Dies are built to work in a certain tonnage (locking pressure) rated machine. Records should always be kept on the exact machine that your tooling is designed to run on. In terms of high speed zinc tooling, there are a myriad of machine models in the industry many of which are proprietary to a particular caster.
Location
Arvalda Corp. P.O. Box 273482 Boca Raton, FL 33427
arvalda@arvalda.com
(888) 588-5415
Office
Boca Raton Florida Melbourne Florida St.
Which casting process will yield a part closest to the desired net shape? How narrow can heatsink fins be specified before they become a problem for the extruder? How should an enclosure be designed for a demanding EMI environment? For over twenty five years we have answered these questions and many more like them. Welcome to our website.
Copyright 2025 Arvalda Corporation © All Right Reserved